iT 악세사리 – INCOSYS Web Site

Model

Description

iT043

3-position cover, for 17.5mm-cased units (iT100/200 series and iT500

iT031

17.5mm TBUS connector, for iT100/200/300 Series and iT500 Series modules

iT032

22.5mm TBUS connector, for iT400 Series modules

iT033

5-position TBUS cable-connector, male receptacle, cable comes in left side horizontal

iT034

5-position TBUS cable-connector, female plug, cable comes in right side horizontal

iT035

5-position TBUS cable-connector, female plug, cable comes in right side vertically

iT042

4-position terminal connection plug for 22.5mm-cased units (iT001/002/004 and iT400 Series)

iT099

120 VAC, 6′ power cord (US outlets); uses standard 120 VAC three-prong plug termination.

iT044

4-position cover, for 22.5mm-cased units (iT001/002/004 and iT400 Series)

iT046

4-position blanks, installed in-place of uninstalled board connectors

iT057

fuse holder, Spare fuse holder used in the iT054. The iT054 is shipped with one iT057.

iT061

5mm x 20mm 2.5 Amp (used when powering an iT001)

iT075

for wires smaller than 0.130″OD (J9A, J9T2, J9T2A, J9T2AS, J9T3, J10, J11)

iT041

3-position terminal connection plug for 17.5mm-cased units (iT100/200 series and

iT077

Small screwdriver for use with the module terminal block screws, large grip and small shank Power

iT062

5mm x 20mm 5 Amp (used when powering an iT002)

iT074

for wires smaller than 0.100″OD (J81, J81S, J8, J6, J61, J5A)

iT059

This DIN block bridge is an aid to quick wiring installation. The “comb” tabs can be broken off quickly for removal. This eliminates wire termination preparation when needing to “bridge” multiple distribution blocks. Busses iT054, iT055, iT056 together without wiring.

iT058

marker strip, “Zack Strip” with custom “L N G” labeling (for “Line,” “Neutral,” and “Ground,” respectively) to use with iT054, iT055, iT056. Labels have the standard terminology for AC mains connections.

iT056

35mm, ground terminal block, Terminal block includes clamp to ground DIN rail and can be used as end-stop. This block is used to pass the AC mains “ground” connection to the power supply. In the US, this is usually the green wire. The block has no disconnect pull and no fuse.

iT055

35mm, unfused terminal block, An unfused terminal block is used to pass the AC mains “neutral” connection to the power supply. In the US, this is usually the “white” wire.

iT054

35mm, fused terminal block, A fused terminal block is used to pass the AC mains “line” connection to the power supply. In the US, this is usually the black wire for single phase power. The removable “pull” fuse can be used as a local point to disconnect when service is required within the DIN box.

iT053

DIN-bracket, 35mm, end-stop

iT064

5mm x 20mm 10 Amp (used when powering an iT004)